Technical Data
Input
Input Signal Potentiometer, 500 Ohm … 100 kOhm
Potentiometer connection 3 wire connection
Input resistance Approx. 10 MOhm
Output
Voltage Current
Output signals
(switch selectable) ± 10 V, 0…10 V, 2…10 V
± 5 V, 0…5 V, 1…5 V ± 20 mA, 0…20 mA, 4…20 mA
± 10 mA, 0…10 mA, 2…10 mA
Load ≤ 10 mA (1 kOhm @ 10 V) ≤ 12 V (600 Ohm @ 20 mA)
Linear transmission range unipolar: –2 … +110 %, bipolar: –110 … +110 %
Ripple < 10 mV rms
General Data
Transmission error < 0,1 % of final value Temperature coefficient 1) 100 ppm/K final value Zero/Span compensation ± 10 % Cut-off frequency(-3 dB) > 1 kHz, switchable to < 30 Hz
Test voltage 4 kV, 50 Hz,
Input against output against power supply
Working voltage 2)
(Basic Insulation) Up to 1000 V AC/DC for overvoltage category II and pollution degree 2 acc. to EN 61010-1 between all circuits.
Protection against electrical shock 2) Protective separation according to EN 61140 by reinforced insulation in accordance with EN 61010-1 up to 600 V AC/DC for overvoltage category II and pollution degree 2 between all circuits.
Ambient temperature Operation
Transport and storage –20 to +70 °C
–35 to +85 °C
Power supply 20…253 V AC/DC, AC 48…62 Hz, approx. 2 VA
DC approx. 1.0 W
EMC 3) EMVG, EN 61326-1
Construction 12.5 mm housing, protection type: IP 20
Weight Approx. 100 g
Average TC in specified operating temperature range
As far as relevant the standards and rules mentioned above are considered by development and production of our devices. In addition relevant assembly rules are to be considered by installation of our devices
in other equipments. For applications with high working voltages, take measures to prevent accidental contact and make sure that there is sufficient distance or insulation between adjacent situated devices.
Minor deviations possible during interference
Bold: factory setting