Technical Data

Input

Input signal 0(4) to 20 mA
Operating current < 200 µA
Voltage drop < 1.9 V
LoopGuard Function
(D62H114X0 only) Input protection against overburden and line break at the output
Load limit adjustable 50 to 600 Ohm, signaling with red LED
Overload ≤ 40 mA, 18 V
Output

Output signal 0(4) to 20 mA
Load 600 Ohm
Cut-off frequency 100 Hz
Response time (T10-90) < 3.5 ms
Ripple < 10 mVrms
General Data

Transmission error < 0.1 %
Load error < 0.05 % of measured value / 100 Ohm load
Temperature coefficient 1) 100 ppm/K
Test voltage 2.5 kV, 50 Hz between all circuits
Working voltage 2)
(Basic insulation) Up to 600 V AC/DC for overvoltage category II and pollution degree 2 acc. to EN 61010-1 between all circuits.
Protection against electrical shock 2) Protective separation according to EN 61140 by reinforced insulation in accordance with EN 61010 -1 up to 300 V AC/DC for overvoltage category II and pollution degree 2 between all circuits.
Ambient temperature Operation
Transport and Storage –25 °C to +70 °C
–40 °C to +85 °C (-13 to +158 °F)
(-40 to +185 °F)
EMC 3) EN 61326-1
Construction 6.2 mm housing, protection class: IP 20
Weight Approx. 50 g
(–13 bis +158 °F)

(­–40 bis +185 °F)
Average TC based on the final value in specified operating temperature range
As far as relevant the standards and rules mentioned above are considered by development and production of our devices. In addition relevant assembly rules are to be considered by installation of our devices in other equipments. For applications with high working voltages, take measures to prevent accidental contact and make sure that there is sufficient distance or insulation between adjacent situated devices.
Minor deviations possible during interference