Technical Data
Input
Input signal 0…20 mA, 4…20 mA, 0…10 V
terminal selectable
Input resistance Current input
Voltage input 22 Ohm
1 MOhm
Overload Current input
Voltage input ≤ 100 mA
Voltage limitation via 30 V Z-Diode, max. continuous current 30 mA
Output
Output signal 0…20 mA, 4…20 mA, 0…10 V,
terminal selectable
Load Current output
Voltage output ≤ 10 V (500 Ohm @ 20 mA)
≤ 10 mA (1 kOhm @ 10 V)
Offset 20 µA / 10 mV
Ripple < 20 mV rms
General Data
Transmission error 0.3 % of measured value
Temperature coefficient 1) 150 ppm/K of final value
Cut-off frequency (-3 dB) Approx. 1 kHz
Test voltage 2.5 kV, 50 Hz
Input against output against power supply
Working voltage 2)
(Basic Insulation) Up to 600 V AC/DC forovervoltage category II and pollution degree 2 acc. to EN 61010-1 between allcircuits.
Ambient temperature Operation
Transport and storage –10 °C to +60 °C
–20 °C to +80 °C
Power supply 24 V DC ±10 % DC approx. 1,2 W
EMC 3) EMVG, EN 61326 -1
Construction Module for pcb assembling, 52.5 x 36 x 15.5 mm (l x w x h)
Weight Approx. 60 g
Average TC in specified operating temperature range
As far as practicable the standards and rules mentioned above are considered by development and production of our devices. In addition the assembly rules for our devices are to be considered by installation in other equipments. For applications with high working voltages, take measures to prevent accidental contact and make sure that there is sufficient distance or insulation between adjacent situated devices.
Minor deviations possible during interference