Technical Data
Input
Input signal 0…20 mA, 4…20 mA
0…5 V, 0…10 V, 1…5 V, 2…10 V
see order information
Input resistance Current input
Voltage input ≤ 50 Ohm
≥ 100 kOhm
Overload Current input
Voltage input ≤ 50 mA
≤ 30 V
Output I + II
Output signal 0…20 mA, 4…20 mA
see order information
Load ≤ 10 V (2x 300 Ohm at 20 mA)
Offset < 20 µA
Ripple < 10 mVeff
General Data
Transmission error < 0,1 % of final value
Temperature coefficient 1) < 100 ppm/K
Cut-off frequency 1 kHz, switchable to 100 Hz
Response time (T10-90) < 300 µs, switchable to < 3,5 ms
Test voltage 2,5 kV, 50 Hz between all circuits
Working voltage 2)
(Basic Insulation) Up to 600 V AC/DC for overvoltage category II and pollution degree 2 acc. to EN 61010-1 between all circuits.
Protection against electrical shock Protective separation according to EN 61140 by reinforced insulation in accordance with EN 61010-1 up to 300 V AC/DC for overvoltage category II and pollution degree 2 between all circuits.
Ambient temperature Operation
Transport and storage –25 °C to +70 °C
–40 °C to +85 °C
Power supply 24 V DC 16,8 V … 31,2 V DC, ca. 1,0 W
EMC 3) EN 61326-1
Construction 6.0 mm housing, protection class: IP 20
Weight Approx. 50 g
Average TC based on the final value in specified operating temperature range
As far as relevant the standards and rules mentioned above are considered by development and production of our devices. In addition relevant assembly rules are to be considered by installation of our devices in other equipments. For applications with high working voltages, take measures to prevent accidental contact and make sure that there is sufficient distance or insulation between adjacent situated devices.
Minor deviations possible during interference
Bold: Factory setting for D6N 21000