Technical Data
Input
Input signal
(calibrated range selection) 0 … 20 mA, 4 … 20 mA
Input resistance ≤ 50 Ohm
Overload 50 mA
Transmitter supply voltage Approx. 18 V
Max. supply current 30 mA
Output
Output signal
(calibrated range selection) 0 … 20 mA, 4 … 20 mA
0 … 10 V, 2 … 10 V, 0 … 5 V, 1 … 5 V
Load Current output
Voltage output < 12 V (600 Ohm at 20 mA)
< 5 mA (2 kOhm at 10 V)
Offset Current output
Voltage output < 20 µA
< 10 mV
Linear transmission range –1 … +110 %
Ripple < 10 mVrms
General Data
Transmission error < 0,1 % of final value
Temperature coefficient 1) < 100 ppm/K
Cut-off frequency (-3 dB) 100 Hz
Response time (T10-90) < 3.5 ms
Test voltage 2.5 kV, 50 Hz between all circuits
Working voltage 2)
(Basic Insulation) Up to 600 V AC/DC for overvoltage category II and pollution degree 2 acc. to EN 61010-1 between all circuits.
Protection against electrical shock 2) Protective separation according to EN 61140 by reinforced insulation in accordance with EN 61010-1 up to 300 V AC/DC for overvoltage category II and pollution degree 2 between all circuits.
Ambient temperature Operation
Transport and storage –25 °C to +70 °C
–40 °C to +85 °C
Power supply 24 V DC, 16.8 V … 31.2 V DC, approx. 1.2 W
EMC 3) EN 61326-1
Construction 6.0 mm housing, protection class: IP 20
Weight Approx. 50 g
Average TC based on the final value in specified operating temperature range
As far as relevant the standards and rules mentioned above are considered by development and production of our devices. In addition relevant assembly rules are to be considered by installation of our devices in other equipments. For applications with high working voltages, take measures to prevent accidental contact and make sure that there is sufficient distance or insulation between adjacent situated devices.
Minor deviations possible during interference
Bold: Factory setting for D6C 52100